Requirements:

• J-ReX
• Vehicle with OBD port
• Ethernet cable

1. Connect the OBD plug of the J-ReX to the OBD port of the vehicle.
2. Connect one end of the Ethernet cable to an available port on the router.
3. Connect the other end of the Ethernet cable to the Ethernet port of the J-ReX.
4. Observe the orange and green LEDs at the Ethernet port and wait until both lights stay on continuously.
5. The front LEDs on top of the J-ReX may turn blue, indicating a firmware update is in progress.
   Important: If a firmware update is running, wait until the LEDs turn green automatically.
6. Once both Ethernet port LEDs stay on continuously and the front LEDs turn green, the J-ReX is successfully connected to the network.